MRI51 - Slow start valve

This fitting allows for a progressive pressurization of the installation and prevents the actuators from being hit hard in case of sudden pressure feeding of the previously vented circuit. The actuators return to their working position smoothly without being hit.

Pressure feeding speed is determined by the rotation of the spindle: if turned clockwise, a very smooth pressurization will be achieved. The valve opens fully once the pressure reaches approximately 2/3 of the inlet pressure.

• Working pressure: 3–10 bar
• Temperature range: -20…+70 °C
• Body: brass UNI EN 12164 CW614N, nickel plated
• Banjo ring: brass UNI EN 12165 CW617N, nickel plated
• Needle: stainless steel AISI 302
• Spring: stainless steel AISI 302
• Seals: NBR-PU
• Gasket: PA6
• Silicone free, RoHS and REACH compliant
• Application field: pneumatic installations fed with filtered, lubricated air

Flow values are measured at 6 bar / ∆p 1 bar. The recommended tubing depends on the fitting connected to the valve.